: Flat ribbon Cable
Synonyme :ribbon cable connector
flat cable connector
flat ribbon cable
ribbon cable repair
flat cable
farnell
radiospares
The flat ribbon cable is a multi-conductor cable in which the conductors are not bundled in one round circular conduit, but are arranged in parallel. It shall be used primarily for connecting multi-pin signal lines in electronic assemblies and computers.
 |
| ribbon cable |
The previously used two-core, symmetric antenna cable (ribbon cable) see volume line.
Multi-core ribbon cables have the advantage that very many cores with little effort by the insulation displacement connections with a post connector, a Lota Adapter or another connector (e.g. D-sub connectors) can be connected instead of individually stripping and then need to solder. Also the crosstalk of signals is in the flat ribbon cable is less than in the round cable and can be identified by the arrangement of the signals and the use of ground lines between critical signals be better controlled.
Most of the time a light gray PVC material, with a red or black edge marks the first conductor. But there are also color-coded flat ribbon cable in the adjacent wires in ten different colors according to DIN IEC 62. For larger flat ribbon cables, repeat the colors after the appropriate number of wires.
Ribbon cable, up to 96 cores. The distance between the wires can be 0.5 mm to 2.54 mm. The most commonly used grid dimension is 1.27 mm (0.05"), because a simple connection with double row post connectors for 2.54mm pin strips is possible.
Flat ribbon cable with a shielding can also, mostly a matter wrapped aluminum or copper foil.
For aerodynamic reasons were in the PC area flat ribbon cable in the last few years in part by round cable replaced because the flat ribbon cable the air flow in the enclosure is much more restrictive than round cable.
ribbon cable connector : special forms
a special form is the flat round cable in which the flat ribbon cable rolled together in a standard round cable with shielding is routed. To connect the remote to scroll and ends on post connector crimping.
Ribbon cable can also be used as twisted-pair cable manufactured, with only the ends as standard ribbon cable are shaped, while always in between two wires are twisted.
The flat ribbon cable is a design that no wire is used, but on polyester applied metal tracks whose ends directly for certain connectors can be attached. This type of international is also known under
the name flat flex cable or FFC known
How to make flat ribbon cables
Included in this video is an overview of the parts and tools needed to make flat ribbon cables for electronics. Any length or plugs per cable is possible, provided that your setup will support your configuration. In this video we will be looking at the cable set for Williams & Bally pinball machines from the 1990s.
Size : flat cable connector
Ribbon cables ar sometimes such that by 2 numbers: the spacing or pitch of the conductors, and also the variety of conductors or ways that. A spacing of zero.05 inch (1.27 mm) is that the most usual,leaving a two-row connection with a pin spacing of zero.1 inch (2.54 mm). These varieties ar used for several sorts of instrumentation, specifically for interconnections among AN enclosure. for privatecomputers, this size is employed nowadays in floppy-disk-drive cables and older or custom Parallel ATA cables.Based on accessibility of normal connectors, the amount of conductors is typically restricted tomany values, These embody four, 6, 8, 9, 10, 14, 15, 16, 18, 20, 24, 25, 26, 34, 37, 40, 50, 60, 64 and 80. The wire is typically stranded copper wire, sometimes either zero.32, 0.20, or 0.13 mm2 (22, 24, or 26 AWG).
Finer and coarser pitch cables are on the market. for example, the high-speed ATA interface cable used for laptop magnetic disk interfaces ULTRA-ATA has zero.025-inch (0.64-mm) pitch. Finer pitches, as tiny as zero.3 mm, ar found in moveable equipment, like laptops; but, moveable equipmentsometimes uses versatile flat cables (FFC).
